application

server

Polyphase and Vcore regulators

Voltage Regulator Modules (VRMs)

Benchtop VRMs and EVRDs

Data Networking and Storage Systems

Graphics card and battery power system

load point module

DCR induction circuit

Environmental data

Storage temperature range (components): -40°C to + 125 °C

Operating temperature range: -40°C to +125°C (ambient + self temperature rise)

Solder Reflow Temperature: Complies with J-STD-020D

Product Description

High load capacity

Low core loss

Frequency range up to 2 MHz

Inductance range from 115 nH to 300 nH

Current range from 32 amps to 94 amps

10.4 x 8.0mm surface mount package

6.5, 7.5 or 7.5mm high

Ferrite Core Material

Halogen Free, Lead Free, RoHS Compliant

1. Open circuit inductance (OCL) test parameters: 100kHz, 0.1Vrms, 0.0Adc, +25°C

2. Full load inductance (FLL) test parameters: 100kHz, 0.1Vrms, Isat1, +25°C

3.RMS: IMRS: DC current is approximately 40℃ without core loss temperature rise. Derating is required for AC current. PCB layout, trace thickness and width, air flow, and proximity of heating elements can affect temperature rise. It is recommended that the temperature of the part does not exceed 125°C in the worst case to end the application.

4.SAT1: Peak current about 20% roll-off @ +25°C

5.SAT2: The peak current is about 20% roll-off @ +125°C

6. K-Factor: Bp-p used to determine core loss (see figure). Bp-p=K*L*△I*10-3. Bp-p: (Gaussian), K: (K factor in the table), fifty: (inductance unit is nH), аI (peak-to-peak ripple current unit is ampere).

7. Part number definition: FP1007Rx-Rxx-RFP1007R=Product code and size x=DCR indicator Rxx=Inductance value (μH), R=Decimal point-R suffix=RoHS complian

Part Marking: FP1007RX (×=DCR Indicator), RXX ((xx=Inductance Value in) UH, R=Decimal Point, WWWLLY=Date Code, R=Revision Level tolerance is ±0.25mm, no other status. PCBs The capacity is ±0.1mm, nothing else to say. All solvent surfaces are coplanar within 0.1mm DCR measured from point a "to point b" Do not be on the roadmap or route below the sensor

Type FP1007

High Frequency High Current Power Inductor Packaging Information (mm) Temperature Rise and Total Loss Available in tape and reel packaging,

FP1007R1 700 parts per 13" diameter reel

FP1007R2 750 parts per 13" diameter reel

FP1007R3 650 parts per 13" diameter roll

Temperature rise and total loss

Type FP1007

High frequency high current power inductor

Tolerances for peak profile temperature (TP) are defined as supplier minimum and user maximum.

The time tolerance on peak profile temperature (TP) is defined as the supplier minimum and user maximum.