illustrate
The A96200 voice recording module provides true single-chip solid-state storage capability that requires no software or microcontroller support. It provides high quality recording and playback with 20 seconds of dual information.
feature

z non-volatile flash technology
Z No backup battery required
Z User-friendly and easy to operate Z slide switch for recording or playback
Z split key triggers message 1 or 2
Z low power consumption
Z LED indicates recording and playback
ZBuilt-in condenser microphone
ZAuto power off
Z 5-6V operation operation record
1. Turn the slide switch to the recording position, press M1 or M2 to start recording, and release the key when the recording is complete. The LEDs will light up during recording. If the voice message exceeds 20 seconds, it will beep twice and the LED will turn off and stop. Record.
2. If there is a previously recorded message, pressing the REC key will delete the previous message and record a new message. playback
1. Turn the slide switch to the play position and press M1 or M2 to start playback. The message will be played from start to finish. In play mode, if the button is pressed to play, the message will stop immediately.
2. If the newly recorded message is shorter than the previously recorded message, the previous message will be deleted.
After the backup item recording or playback operation is completed, the module will automatically enter standby mode. Connectors and Switches

Record
1. Turn the slide switch to the recording position, press M1 or M2 to start recording, and release the key when the recording is complete. The LEDs will light up during recording. If the voice message exceeds 20 seconds, it will beep twice and the LED will turn off and stop. Record.
2. If there is a previously recorded message, pressing the REC key will delete the previous message and record a new message. playback
1. Turn the slide switch to the play position and press M1 or M2 to start playback. The message will be played from start to finish. In play mode, if the button is pressed to play, the message will stop immediately.
2. If the newly recorded message is shorter than the previously recorded message, the previous message will be deleted. After the backup item recording or playback operation is completed, the module will automatically enter standby mode. Connector and Switch SPK 0.1" Pitch Pin Header for Speaker PWR 0.1" Pitch Pin Connector for DC Power, Note Polarity Selection Slide Switch for Record/Play M1 Message 1 Button Info 2 M2 Button for Electrical Specifications