This 16-bit non-inverting bus transceiver uses two

1 Logic IC SN74AVC16T245DGG. Control input VIH/VIL levels are referenced to separate configurable power rails. The optimized logic IC SN74AVC16T245DGG device operates with ?VCC isolation function - SN74AVC16T245 if either VCC input is set to 1.4 V to 3.6 V at VCCA/VCCB. The device is GND, both ports are in a high impedance state with VCCA/VCCB as low as 1.2 V. The A port is used to track VCCA. VCCA accepts any ? tolerant input and output, allowing supply voltages from 1.2 V to 3.6 V. Port B is for mixed voltage mode data communication and is used to track VCCB. ? Fully configurable dual rail design, SN74AVC16T245 allows each voltage from 1.2 V to 3.6 V. This enables the general purpose port to perform full 1.2-3.6 V low voltage bidirectional translation between any supply in the 1.2-V, 1.5-V, 1.8-V, 2.5-V and 3.3-V voltage ranges. The SN74AVC16T245Ioff supports partial power down mode operation of the node. The logic integrated circuit SN74AVC16T245DGG device is designed for maximum data rate asynchronous communication between data buses. The device transfers data from bus to B - 380 Mbps (1.8 V to 3.3 V level shifting) bus or from B bus to bus, according to - 200 Mbps (< 1.8 V to 3.3 V level shifting) The SN74AVC16T245 is a 16-bit, Logic integrated circuit SN74AVC16T245DGG dual power non-inverting bidirectional voltage level translation. Pin A and control pins (DIR and OE) are supported by VCCA, and pin B is supported by VCCB. The A port can accept I/O voltages from 1.2 V to 3.6 V, and the B port can accept I/O voltages from 1.2 V to 3.6 V. When OE is set low, the high directory allows data to be transferred from A to B, and the low directory allows data to be transferred from B to A. When OE is set high, both A and B are in a high impedance state. The device is fully suitable for partial power down applications using off output current (Ioff). The VCC isolation feature ensures that if either VCC input is at GND, both ports are in a high-impedance state The SN74AVC16T245 is a voltage level translator that can operate between 1.2 V to 3.6 V (VCCA) and 1.2 V to 3.6 V (VCCB) Work. Signal conversion between 1.2 V and 3.6 V requires direction control and output enable control. When OE is low and DIR is high, data transfer is from A to B. When OE is low and DIR is low, data transfer is from B to A. When OE is high, both output ports are high impedance

Shenzhen Tianzhuo Weiye Electronics Co., Ltd.

In the past 10 years, Shenzhen Tianzhuo Weiye Electronics Co., Ltd. has seized the historical opportunities brought by China's reform and opening up and the rapid development of the electronics industry, adhered to customer-centricity and high-quality products as the foundation, and provided customers with one-stop procurement services for components. Won the respect and trust of customers, from an entrepreneurial company based in Huaqiangbei, Shenzhen Special Economic Zone, China, it has grown steadily into an electronic component supplier with several well-known brand product lines and customers in many countries and regions around the world. The electronic IC and 3C distributed and wholesaled sell well in the consumer market and enjoy a high status among consumers. The company has established long-term and stable cooperative relations with many retailers and agents.