MSK5232-3.3HTD original factory authorized source channel, guarantee imported original authentic, fake one penalty ten reasonable price, all in-Yujixin Electronics

MSK5232-3.3HTD

feature:

Series Sealed Surface Mount Assembly Options

Very low drop voltage: 350mV@3A

Available in 1.5V, 1.7V, 1.8V, 1.9V, 2.5V, 3.3V, 5.0V and 12.0V

On-board thermal shutdown

Reverse battery and load shedding protection

Low ground current: 32mA typical at full load

1% maximum guaranteed accuracy

Output current is 3 amps

Selectable output voltage

Improved replacement for 0.185sr

There are four main configurations

Available in top tab or tableless packaging

illustrate:

MSK 5232 series regulators provide +1.5 V, +1.7 V, +1.8 V, +1.9 V, +2.5 V, +3.3 V, +5.0 V,

and +12.0V output configuration. All have ultra-low exit specs due to the use of super PNPs.

Output pass transistor using monolithic technology. In this configuration, the output voltage at 3 amps is 350mV,

This improves efficiency and reduces power consumption. Guaranteed accuracy, maximum output is 1%_

voltage tolerance. The housing of the MSK5232 series is electrically insulating for heat dissipation. MSK5232

The series is packaged in a space efficient 3-pin power pack that can be used for surface mounting.

application. The device is also available in a power pack with a lug on top to accommodate direct mounting to thermal equipment.

sink.

typical application

High Efficiency, High Current Linear Regulators

Constant Voltage/Constant Current Regulator

System power

Switching power post regulator

battery powered equipment

Regulator Protection:

MSK 5232 series is fully protected against inversions

Input Polarity, Over Current Fault, Over Temperature Condition

(pd) and transient voltage peaks up to 60V.

regulators are used in dual-supply systems where

The load returns to the negative supply, the output voltage

The diode must be clamped to ground.

Output capacitor:

MSK 5232 Series Voltage Output Voltage Ripple

The regulator can be minimized by placing filter capacitors.

from output to ground. best value

Because this capacitor is used in different applications

Next step, but at least 20µF is recommended for best

performance. Transient load response can also be

Improved by placing capacitors directly on the load.

Capacitors should not be of the ultra low ESR type. Tantalum

Capacitors are best for fast load transients, but

Aluminum electrolysis works well in most applications.