PIC16F630-I/SL long-term supply in stock Galina Electronics 0755-83216147

High-performance RISC CPU:

Only 35 Instructions to Learn

- All single-cycle instructions except branches

Speed of work:

- DC - 20 MHz oscillator/clock input

- DC - 200 ns instruction cycle

interrupt capability

8-level deep hardware stack

Direct, indirect and relative addressing modes

Low power consumption features:- Standby current:

- 1 nA @ 2.0V, typical

Working current: - 8.5/?A

@ 32 kHz, 2.0V, typical

- 100 ?A

@ 1 MHz, 2.0V, typical

Watchdog Timer Current

- 300 nA @ 2.0V, typical

Timer1 Oscillator Current: - 4 µA

@ 32 kHz, 2.0V, typical

Microcontroller Features Internal and External Oscillator Options

- Accurate internal 4 MHz oscillator factory

Calibrated to ±1%

- Support for external crystal oscillators and

Resonator - 5s

wake-up from sleep, 3.0V, typical

Power saving sleep mode

Wide Operating Voltage Range - 2.0V to 5.5V

Industrial and Extended Temperature Ranges

Low-Power Power-On Reset (POR)

Power-up Timer (PWRT) and Oscillator Start-up

Timer ( OST )

Brown-out Detection (BOD)

Watchdog Timer (WDT) with independent

oscillator for reliable operation

Multiplexed MCLR/input pin

Interrupt pin level change

Independent programmable weak pull-ups

Programmable code protection

High Endurance Flash/EEPROM Cells

- 100,000 write FLASH endurance

- Million write EEPROM endurance

- FLASH/EEPROM data retention: > 40

Memory FL gray (word) 1024

Data Memory: SRAM

(bytes) 64

EEPROM

(byte)

128

Peripheral Features: 12 I/O pins with independent direction control

High sink/source current to directly drive LEDs

Analog Comparator Module:- One Analog Comparator

- Programmable on-chip voltage comparator

Reference (CVREF) module

- Programmable input multiplexing of slave devices

Input comparator output for external access

Analog to Digital Converter Module (PIC16F676):

- 10-bit resolution

- Programmable 8-channel input

- Voltage reference input

Timer 0: 8-bit timer/counter, 8-bit

Programmable Prescaler

Enhanced timers:

- 16-bit timer/counter with prescaler

- External gate input mode

- Option to use OSC1 and OSC2 in LP mode

As Timer1 oscillator, if INTOSC mode

In-Circuit Serial Programming

TM (ICSP)