AD1580BRTZ-REEL7_AD1984BJCPZ-RL Introduction

The low IQ of the TPS62840 enables 80% efficiency at 1-µA loads, 30% higher than comparable devices in the industry. Longer battery life and very high light load efficiency: Lower IQ consumption provides longer IQ for very light loads (below 100µA) and systems operating primarily in standby/factory mode (no switching) battery life. .

The charger can provide a power density of 155 mW/mm2 (100 W/in2), which is about twice higher than the market. The new buck-boost charger helps engineers reduce solution size and bill of materials (BOM) and is TI's only device that fully integrates: .

AD1580BRTZ-REEL7_AD1984BJCPZ-RL

AD1580ARTZ

AD1021AARQZ AD1021AARQZ AD1021ARQ AD1021RQ AD1021RQ.

AD1583BRTZ AD1583BRTZ AD1583BRTZ-REEL7 AD1583BRTZ-REEL7 AD1583BRTZ-REEL7.

AD1580ARTZ-REEL AD1580ARTZ-REEL7 AD1580ARTZ-REEL7 AD1580ARTZ-RL7 AD1580-B.

AD1583ARTZ-REEL7 AD1583ARTZ-REEL7 AD1583ARTZ-RL7 AD1583BRT-REEL7 AD1583BRT-REEL7.

AD1580BRTZ-REEL7_AD1984BJCPZ-RL

AD2S1205WSTZ

AD1584ARTZ-REEL7 AD1584BRT-R2 AD1584BRTZ AD1584BRTZ AD1584BRTZ-R7.

AD1585BRTZ AD1585BRTZ-R2 AD1585BRTZ-REEL7 AD1585CRTZ AD1589336(AD3703).

AD1028ARQ AD1028ARQ AD1030ARQ AD1030ARQ AD1031A-RQ.

AD1585ART-REEL7 AD1585ARTZ-R2 AD1585ARTZ-REEL7 AD1585ARTZ-REEL7 AD1585BRTZ.

AD1580BRTZ-REEL7_AD1984BJCPZ-RL

?? Because only the edge part is in contact with the underlying substrate, this structure is relatively fragile when under pressure, and similar to the membrane type, the heat dissipation problem also needs attention. In the Airgap type, an auxiliary layer (sacrificial support layer) is deposited before the piezoelectric layer is formed, and finally the auxiliary layer is removed to form an air gap under the oscillating structure.

The BAW filter is more suitable for frequencies above 2.5GHz. The manufacturing process of the BAW filter is also very consistent with the existing IC manufacturing process, and is suitable for overall integration with other active circuits. .

relevant information