CJ9926_AFN4946WS8RG Introduction

In simple terms, the motor is driven by the output current of the MOS tube such as NCE80H12. The larger the output current (in order to prevent overcurrent from burning the MOS tube, the controller has limited current protection), the motor torque is strong and the acceleration is powerful, so MOS Tubes play a very important role in electric vehicle controllers.

Today I will introduce to you a domestic FET that is suitable for lithium battery protection boards and can replace MOS tubes such as AO3401: NCE3401.

CJ9926_AFN4946WS8RG

BYM6650

BYS3105 BYP3105 BYJ31020A BYH31012A BYJ31012A BYP3104 BYF31010A BYP31013A BYS31010A BYH31055 .

NCE3019AS NCE3045G NCE3400AY NCE30ND07S NCE8601B.

Barrier capacitance: In power semiconductors, when the N-type and P-type semiconductors are combined, the electrons of the N-type semiconductor will partially diffuse into the holes of the P-type semiconductor due to the concentration difference, so they will form on both sides of the junction surface. Space charge area (the electric field formed by the space charge area will resist the diffusion movement, and finally make the diffusion movement reach equilibrium);

BYN41020A BYM41019A BYM41063 BYM429 BYN4286 BYT4222 BYN4224 BYC4213 BYM4225.

CJ9926_AFN4946WS8RG

P2804HVG & Special 30V

The structure of the MOSFET shown in the figure is not suitable for use in high-power applications for two reasons. On the one hand, the three electrodes of the low-power MOSFET are on one plane, the channel cannot be made very short, and the channel resistance is large. On the other hand, the conductive channel is composed of surface induced charges, and the channel current is the surface current. To increase the current capacity, it is necessary to increase the chip area. Such a structure is unlikely to achieve a large current. .

When the UDS increases to a certain value, the drain PN junction breaks down, the leakage current increases rapidly, and the curve turns upward and enters the breakdown region. Power MOSFETs are used in power conversions such as switching power supplies and inverters, and they work in two regions, the cut-off region and the breakdown region. . The full area (UDS>UGS-UT) guarded in the above three areas is the full area, also known as the constant current area or the amplification area. The breakdown region is in the region of considerable drain-source voltage UDS, and the drain current is approximately constant.

BYP31036 BYD31010A BYD31024A BYP31017 BYS31018 BYF3104 BYH3108 BYF3109 BYM31032 BYN31333A .

The parasitic capacitance structure of the MOS tube is as follows. Among them, the width of polysilicon, the width of the channel and the trench, the thickness of the G oxide layer, and the doping profile of the PN junction are all factors that affect the parasitic capacitance. .

CJ9926_AFN4946WS8RG

The lithium battery is mainly composed of two blocks, the battery cell and the lithium battery protection board PCM.

NCE20ND06 NCE2008N NCE2312 NCE2312A NCE8205A.

relevant information