BYM6318_AFN4924S8RG Introduction

MOS tubes like NCE80H12 convert the DC power in the battery into AC power when the electric vehicle is running normally, thereby driving the motor to run.

The resistance of this current path is called the internal resistance of the MOS tube, that is, the on-resistance. The size of this internal resistance basically determines how much on-current the MOS tube chip can withstand (of course, it is related to other factors, such as thermal resistance). The smaller the internal resistance, the larger the current (because the heat is small).

BYM6318_AFN4924S8RG

9936M

Barrier capacitance: In power semiconductors, when the N-type and P-type semiconductors are combined, the electrons of the N-type semiconductor will partially diffuse into the holes of the P-type semiconductor due to the concentration difference, so they will form on both sides of the junction surface. Space charge area (the electric field formed by the space charge area will resist the diffusion movement, and finally make the diffusion movement reach equilibrium);

MOS tube 3306 product features 1. RDS(on)=7mΩ@VGS=10V 2. Lead-free green equipment 3. Low resistance switch to reduce conduction loss 4. High avalanche current.

However, in terms of structure, there is a big difference between them. In order to better understand the mechanism of power MOSFET, we must first recall the mechanism of low-power FET. . The following describes the principle of the MOS transistor with the structure of an N-channel enhancement type low-power MOSFET. Working principle of power MOS tube Power MOS tube is developed from low-power MOS tube.

There are three parasitic capacitance parameters in the MOS tube specification, namely: input capacitance Ciss, output capacitance Coss, and reverse transfer capacitance Crss. What do the three capacitance parameters represent in the body of the tube? How did it form? .

BYM6318_AFN4924S8RG

AO4840

NCE3020K NCE3025Q NCE3035K NCE3025G NCE3030K.

When the UDS increases to a certain value, the drain PN junction breaks down, the leakage current increases rapidly, and the curve turns upward and enters the breakdown region. Power MOSFETs are used in power conversions such as switching power supplies and inverters, and they work in two regions, the cut-off region and the breakdown region. . The full area (UDS>UGS-UT) guarded in the above three areas is the full area, also known as the constant current area or the amplification area. The breakdown region is in the region of considerable drain-source voltage UDS, and the drain current is approximately constant.

BYM8615 BYH8638 BYN8610A BYM8628 BYN8222 BYM31020 BYS31010 BYJ3104 BYH3105 BYP3109.

Another technique is to intermittently improve the structure of the MOSFET and use a straight V-groove structure. In order to avoid the problems of too small current-carrying capacity and large on-resistance of MOSFET, two techniques are generally used in high-power MOSFETs. One is to connect millions of low-power MOSFET unit cells in parallel to improve the current-carrying capacity of MOSFET. . FIG. 3 is a cross-sectional view of the structure of a V-channel MOSFET.

BYM6318_AFN4924S8RG

NCE2302D NCE2302F NCE1012E NCE2302B NCE2302.

The main functions of the lithium battery protection board are: 1 overcharge protection, 2 short circuit protection, 3 over current protection, 4 over discharge protection, 5 normal state.

relevant information