BYH343_SP8K3-TB Guide

In simple terms, the motor is driven by the output current of the MOS tube such as NCE80H12. The larger the output current (in order to prevent overcurrent from burning the MOS tube, the controller has limited current protection), the motor torque is strong and the acceleration is powerful, so MOS Tubes play a very important role in electric vehicle controllers.

The resistance of this current path is called the internal resistance of the MOS tube, that is, the on-resistance. The size of this internal resistance basically determines how much on-current the MOS tube chip can withstand (of course, it is related to other factors, such as thermal resistance). The smaller the internal resistance, the larger the current (because the heat is small).

BYH343_SP8K3-TB

BYE4625Z

BYS3105 BYP3105 BYJ31020A BYH31012A BYJ31012A BYP3104 BYF31010A BYP31013A BYS31010A BYH31055 .

BYP31538 BYP31510 BYP31575 BYH31574 BYD31523A BYH31532 BYM31580 BYH31519 BYS31535 BYM31545 .

MOS tube 3306 product features 1. RDS(on)=7mΩ@VGS=10V 2. Lead-free green equipment 3. Low resistance switch to reduce conduction loss 4. High avalanche current.

NCE3019AS NCE3045G NCE3400AY NCE30ND07S NCE8601B.

BYH343_SP8K3-TB

AP9960AGM-HF

The N-channel enhancement mode MOS transistor uses a low-doped P-type semiconductor as the substrate, and forms two heavily doped N+ regions on the substrate by a dispersed method, and then generates a very thin one on the P-type semiconductor. A silicon dioxide insulating layer, and then photolithography is used to etch away the silicon dioxide layer on the upper end of the two heavily doped N+ regions, exposing the N+ regions, and finally on the outer surface of the two N+ regions and the two between them. The surface of silicon oxide is sprayed with a layer of metal film by evaporation or sputtering. These three metal films constitute the three electrodes of the MOS tube, which are called source (S), gate (G) and drain (D) respectively. .

When the low UDS separate pinch off voltage is large, the MOS tube is equivalent to a resistance, and this resistance decreases with the increase of UGS. Cut-off area (UGS). Growth slows as the conduction channel approaches pinch off. Figure 1. Drain output characteristics of MOS transistors The output characteristics of field effect transistors can be divided into four regions: variable resistance region, cut-off region, breakdown region and constant current region. Variable resistance region (UDS In this region, ID increases linearly as UDS increases.

Another technique is to intermittently improve the structure of the MOSFET and use a straight V-groove structure. In order to avoid the problems of too small current-carrying capacity and large on-resistance of MOSFET, two techniques are generally used in high-power MOSFETs. One is to connect millions of low-power MOSFET unit cells in parallel to improve the current-carrying capacity of MOSFET. . FIG. 3 is a cross-sectional view of the structure of a V-channel MOSFET.

BYP31036 BYD31010A BYD31024A BYP31017 BYS31018 BYF3104 BYH3108 BYF3109 BYM31032 BYN31333A .

BYH343_SP8K3-TB

NCE2302C NCE8205t NCE2004Y NCE2006Y NCE2007NS.

The main functions of the lithium battery protection board are: 1 overcharge protection, 2 short circuit protection, 3 over current protection, 4 over discharge protection, 5 normal state.

relevant information