BYJ31040_AO4884&Special 30V Guide

Assuming that the carriers of the conductive channel are electrons, it is called an N-channel; assuming that the carriers are holes, it is called a P-channel. According to the carrier of the conduction channel, it can be divided into N channel and P channel. A MOS tube is a semiconductor device in which unipolar carriers participate in conduction.

The power mos used on electric vehicles is a three-dimensional structure. The mos tube we have seen is actually composed of thousands of small mos tubes in parallel. You may think that one or a few bad moss should easily appear in thousands of small mos. In fact, it is not that easy. , the current manufacturing process basically guarantees the high consistency of various parameters of these small units. Low-power mos is a planar structure.

BYJ31040_AO4884&special 30V

APM9926AKC-TRL

. The conductive channel of the MOS tube can be formed during the production process or by turning on an external power supply. When the gate voltage is equal to zero, there is a channel (that is, formed during production), which is called depletion mode. When an external voltage is applied The one that forms the channel later is called the enhancement type.

The reason is that the on-resistance is small and it is easy to manufacture. Therefore, in the application of switching power supply and motor drive, NMOS is generally used.

MOS tube 3306 product features 1. RDS(on)=7mΩ@VGS=10V 2. Lead-free green equipment 3. Low resistance switch to reduce conduction loss 4. High avalanche current.

NCE30H11K NCE3402B NCE30H10AK NCE2304 NCE3404.

BYJ31040_AO4884&special 30V

BSO604NS2

NCE3008M NCE3010S NCE3011E NCE30D0808J NCE3018AS.

The parasitic capacitance structure of the MOS tube is as follows. Among them, the width of polysilicon, the width of the channel and the trench, the thickness of the G oxide layer, and the doping profile of the PN junction are all factors that affect the parasitic capacitance. .

BYM4610 BYM4640 BYM4875 BYM81080 BYM81095 BYM826 BYM8311 BYM8315 BYH8415 BYM8415.

The structure of the MOSFET shown in the figure is not suitable for use in high-power applications for two reasons. On the one hand, the three electrodes of the low-power MOSFET are on one plane, the channel cannot be made very short, and the channel resistance is large. On the other hand, the conductive channel is composed of surface induced charges, and the channel current is the surface current. To increase the current capacity, it is necessary to increase the chip area. Such a structure is unlikely to achieve a large current. .

BYJ31040_AO4884&special 30V

NCE25TD120WT NCE25TD120VT NCE15TD120LT NCE25TD120LT NCE40TD135LT.

The main functions of the lithium battery protection board are: 1 overcharge protection, 2 short circuit protection, 3 over current protection, 4 over discharge protection, 5 normal state.

relevant information