BYP3104_AO4816 Introduction

A few days ago, Vishay Intertechnology, Inc. announced that it has expanded its TNPU e3 series of automotive-grade high-precision thin-film flat chip resistors with new devices with a temperature coefficient (TCR) as low as 2 ppm/K, in 0603, 0805 and 1206 form factors.

MOS tubes like NCE80H12 convert the DC power in the battery into AC power when the electric vehicle is running normally, thereby driving the motor to run.

BYP3104_AO4816

CEM8912

As for why not to use depletion-type MOS tubes, it is not recommended to get to the bottom of it. . For these two enhanced MOS tubes, NMOS is more commonly used.

BYP31538 BYP31510 BYP31575 BYH31574 BYD31523A BYH31532 BYM31580 BYH31519 BYS31535 BYM31545 .

The reason is that the on-resistance is small and it is easy to manufacture. Therefore, in the application of switching power supply and motor drive, NMOS is generally used.

Power MOSFETs are generally rarely used in P-channel. Since the mobility of holes is lower than that of electrons, the on-resistance of P-channel transistors is larger than that of N-channel transistors for the same channel size. . According to the two points of the conductive channel and the process of channel formation, MOS tubes can be divided into: P-channel enhancement MOS tubes, P-channel depletion MOS tubes, N-channel enhancement MOS tubes and N-channel depletion MOS tubes . Figure four types of MOSFETs and their graphical symbols.

BYP3104_AO4816

SSM7002DGU

For example, electronic fuel injection system, anti-lock brake control, anti-skid control, traction control, electronically controlled suspension, electronically controlled automatic transmission, electronic power steering, etc. The electronic device that can be used independently in the environment has no direct relationship with the performance of the car itself. .

The structure of the MOSFET shown in the figure is not suitable for use in high-power applications for two reasons. On the one hand, the three electrodes of the low-power MOSFET are on one plane, the channel cannot be made very short, and the channel resistance is large. On the other hand, the conductive channel is composed of surface induced charges, and the channel current is the surface current. To increase the current capacity, it is necessary to increase the chip area. Such a structure is unlikely to achieve a large current. .

Diffusion capacitance: When a forward voltage is applied, the non-equilibrium minority carrier concentration near the interface of the depletion layer is high, far from the non-equilibrium minority carrier concentration is low, and the concentration gradually decays from high to 0 until it reaches zero. The process of charge accumulation and release in this phenomenon is the same as that of capacitor charging and discharging, which is called diffusion capacitance. When the applied forward voltage increases, the concentration of unbalanced minority carriers increases and the concentration gradient also increases, and when the applied voltage decreases, the change is opposite.

BYM8615 BYH8638 BYN8610A BYM8628 BYN8222 BYM31020 BYS31010 BYJ3104 BYH3105 BYP3109.

BYP3104_AO4816

NCE8205B NCE8205 NCE8205i NCE8205E NCE9926.

NCE2302C NCE8205t NCE2004Y NCE2006Y NCE2007NS.

relevant information