BYS31018_AP4226GM Introduction

In addition to the above-mentioned NCE80H12 suitable for electric vehicle controllers, Nanshan Electronics also provides Fenghua resistance-capacitance sense, long-crystal MOS transistors, Epson active and passive crystal oscillators, etc.

The power mos used on electric vehicles is a three-dimensional structure. The mos tube we have seen is actually composed of thousands of small mos tubes in parallel. You may think that one or a few bad moss should easily appear in thousands of small mos. In fact, it is not that easy. , the current manufacturing process basically guarantees the high consistency of various parameters of these small units. Low-power mos is a planar structure.

BYS31018_AP4226GM

SSM9926-A

. The conductive channel of the MOS tube can be formed during the production process or by turning on an external power supply. When the gate voltage is equal to zero, there is a channel (that is, formed during production), which is called depletion mode. When an external voltage is applied The one that forms the channel later is called the enhancement type.

NCE30H11K NCE3402B NCE30H10AK NCE2304 NCE3404.

BYS3105 BYP3105 BYJ31020A BYH31012A BYJ31012A BYP3104 BYF31010A BYP31013A BYS31010A BYH31055 .

NCE3404Y NCE3400A NCE3400 NCE30ND07AS NCE3008N.

BYS31018_AP4226GM

AP9962M

BYM8615 BYH8638 BYN8610A BYM8628 BYN8222 BYM31020 BYS31010 BYJ3104 BYH3105 BYP3109.

. The characteristics of a MOSFET can be characterized by a transfer characteristic curve and a drain output characteristic curve. Figure 3 shows the handling characteristics of a certain FET. The transfer characteristic refers to the relationship curve between the gate voltage UGS and the corresponding drain current ID when the voltage UDS between the drain and the source is at a certain fixed value.

The N-channel enhancement mode MOS transistor uses a low-doped P-type semiconductor as the substrate, and forms two heavily doped N+ regions on the substrate by a dispersed method, and then generates a very thin one on the P-type semiconductor. A silicon dioxide insulating layer, and then photolithography is used to etch away the silicon dioxide layer on the upper end of the two heavily doped N+ regions, exposing the N+ regions, and finally on the outer surface of the two N+ regions and the two between them. The surface of silicon oxide is sprayed with a layer of metal film by evaporation or sputtering. These three metal films constitute the three electrodes of the MOS tube, which are called source (S), gate (G) and drain (D) respectively. .

NCE3008M NCE3010S NCE3011E NCE30D0808J NCE3018AS.

BYS31018_AP4226GM

The lithium battery of electric vehicles can work normally, largely thanks to the lithium battery protection board.

The functions of the MOS tube in the protection board are: 1. Detect overcharge, 2. Detect over-discharge, 3. Detect over-current during charging, 4. Detect over-current during discharge, 5. Detect over-current during short circuit.

relevant information