Features single -chip digital audio interface receiver (DIR), including the low shake clock recovery system IEC958), Jeita CPR-1205 (formerly EIAJ CP-1201, CP-340), AES3, EBU Tech3250 input signals from dual-phase input signals for clock recovery and data decoding, which is usually called S/ S/ usually called S/ S/ usually called S/ S/ usually called S...
Read more
Description LM2576 The series stabilizer is the ideal choice of single -chip integrated circuit applies to a simple design (antihypertensive converter) for antihypertensive switch staber. All circuits in this series can drive 3.0 -load to have excellent lines and load adjustment functions. These devices have a fixed output voltage of 3.3V, 5.0V, 12V, 15V, and the output voltage can ...
Read more
Features Provides lead full differential input, output and feedback Differential input range ± 2.3V 550MHz 3DB bandwidth 1100V/μs conversion rate 20MHz #8226; single 5V or dual ± 5V power supply 40mA maximum output current Low-power -12.5ma typical power supply current Application Application Application Applic...
Read more
General description lm2641 is a dual -voltage power controller suitable for laptop and other battery power supply equipment. The fixed -frequency synchronous driving power MOSFET of the logic level N channel and the pulse jump mode of the ultra -high -efficiency power conversion in the range of 1000: 1 load current range. The pulse beating mode can be disabled, which is conducive to...
Read more
Features Single H bridge current control motor drive 8.2-v to 45-v working power supply voltage range # 8226; 5 -bit current control allows up to 32 current levels low MOSFET RDS (open), typical 0.65 (HS+LS) #8226 The maximum driver current at 24 V is 5 A, TA 25 ° C built -in 3.3V reference output ] thermal enhancement surface installation com...
Read more
Features high power 5V to 1.xv-3.xv switch controller: can output more than 10A maximum duty cycle gt; 90%, allow 3.3V To 2.xv Use 5V low -power power supply for conversion All N -channel outer MOSFET Frequently operating small L excellent output adjustment: More than the line ± 1%, load and temperature change High efficiency: 95%or more No low -value res...
Read more
Features 55 μA power current 400μV typical offset voltage 500Pa input bias current 400kHz gain bandwidth multiplication 1MB bandwidth -3MHz 0.13V/μs conversion rate #8226 : The single power supply runs to 2.4V rail input and output Provide lead -free and annealing (compliance with ROHS standard) Application battery or solar system 4...
Read more
General description lm6181 current feedback amplifier provides an unparalleled combination bandwidth, conversion rate and output current. The amplifier can directly drive up to 100 PF capacitor loads without oscillation, 10V signal input 50 or 75 The temperature range of the coaxial cable system on the back of the entire industrial system. This represents a thorough enhancement of ...
Read more
Features Suitable for car applications is an ideal selection of single batteries, dual batteries or three batteries lithium ions and lithium-polymers for high-efficiency charger design The battery pack It is also applicable to the LIFEPO4 battery (see using the BQ24105 to charge the LIFEPO4 battery) Integrated synchronous fixed frequency pulse controller to work...
Read more
Features ■ 5V ± 4%, 500mA output voltage ■ Control function compatible with μP. ) ■ Low static current (7mA@500MA) ■ Low noise, low drift ■ Low -current sleep mode (IQ 250 μA) ■ Failure protection -The hot shutdown -Shamournation -60V peak transient state -Plotic Explanation [ [ [ [ [ 123] CS8140 is a 5V door dog regulator with a protective...
Read more
0.6 to 5.5V working input voltage 1V starts input voltage Internal synchronization rectifier Zero -off current 3.3V and 5V fixed fixation Or adjustable Output voltage (2V to 5.2V) 120m Internal source switch Battery low voltage detection reverse battery Protection Application One to three battery devices PDA and handheld instrument mobile phone-numeric ...
Read more