Features LM2766 CMOS charge pump voltage converter Input power supply voltage doubled as a permanent input voltage SOT-23 6针封装，1.8 V至5.5 V，两个低成本电容器20Ω典型输出阻抗和二极管用于提供20毫安20毫安输出电流时，90%的典型Conversion efficiency. The typical shutdown current of 0.1-μA LM2766 works under 200 kHz Reduce the frequency of the output resistance and v...
Read more
Features The working voltage is +1.7 v to ± 18 v Low power current: 15μA/amplifier Low offset voltage: maximum 100 μV [ [ 123] Output Hui source: ± 8 ma No phase reversal Single power supply or dual power operation High -open ring gain: 600 v/mv Get obtained Stable and unified Application Digital scale Resistance Portable medical equipment Battery pow...
Read more
Features 2.4 V to 3.6 V single power supply operation ± 2 g/± 6 g users can choose a full marker Low power consumption [ 123] The proportion of output voltage, offset and sensitivity to the power supply voltage Factory fine -tuning device sensitivity and offset Embedded self -inspection conforms to ROHS/ECOPACK #174; Standard High impact survival ability (100...
Read more
Features Field effect transistor input amplifier 1 PA input bias current Low cost High -speed: 145 MHz, 3 DB bandwidth (G u003d+1) 180 V/μs conversion rate (g u003d+2) Low noise 7 nv/√Hz (f u003d 10 10 kHz) 0.6 FA/√ Hertz (f u003d 10 kilow) Wide power supply voltage range: 5 V to 24 v Single power supply and rail pairing [ 123] The maximum offset volt...
Read more
General description LM2984C positive voltage regulator has three independent tracking outputs, which can provide memory circuit, peripheral sensor and spare power at the typical microprocessor system. LM2984C includes monitoring circuit output of its own high current and an external MP. If any error conditions will be set and keep the reset error logo until the failure is terminated. ...
Read more
1. Features Working power supply voltage 8V to 20V, Overvoltage maximum 40V Work power supply voltage 6V The increased voltage transformation transformation of realization Instrument Static current in standby less than 50 μA ISO 9141 compatible interface Charging pump driving power supply MOS as a as a MOS as a as a Reverse battery protection PWM ope...
Read more
Features Low offset voltage: maximum 100 V Low input bias current: maximum 10 mAh Single power operation: 3.0 V to 30 V [ 123] Dual power operation: 1.5 V to 15 V Low power current: maximum 300 A/A The unit gain stable No phase reversal ] Application induction (diversion) Line or battery power supply instrument Remote sensor Precision filter and and an...
Read more
Features Quick throughput: 250 KSPS VDD low power for 2.35 V to 5.25 V , 250 KSPS, 3 volt power at 250 KSPS is 13.5 mW, 5 V power supply Wide input bandwidth: When the input frequency is 100 kHz, the minimum signaling of the minimum signaling noise is The ratio is 71 db Flexible power/serial clock speed management Pipeless delay High -speed serial int...
Read more
Explanation LX1970 is a sensor with a new technical lamp with spectral response to imitate human eyes. This device is the system of monitoring ideal equipment brightness control in the system of environmental light flat display. It has a unique photoelectric diode configuration (patent to be determined) peak response at 520 nm and the two types of ultraviolet rays and infrared wavelengths....
Read more
Features 0V, VCC, 12V or Hi-Z digital selection 120mA output current capacity Internal current limit and heat shutdown [ 123]从3.3V自动切换至5V从未经调节的13V至20V电源供电逻辑兼容标准PCMCIA控制器1μF输出电容器[ 123] 30 μA static current in Hi-Z or 0V mode VPP valid status feedback signal No VPP overrun 8-needle SO packaging Application Note c...
Read more
Features Low input offset voltage: maximum 75 μV Low offset voltage drift, exceeding -55 ℃ lt; ta lt;+125 ℃: Most largest 0.5 μV /℃ Low power current (each amplifier): maximum 725 μA High open ring gain: 5000 V/MV min Low input bit Placement current: maximum 2 na Low noise voltage density: 1 kHz at 11 nv/√Hz Stable under large capacitance load: 10 nf ...
Read more