Features Suitable for car applications AEC-Q100 test guide, including the following: -Device temperature level 1:- 40 ° C to+125 ° C The environment of the environment -Equipment HBM ESD classification level: - OPA171-Q1 3A - OPA2171-Q1 level 3A -2 OPA4171-Q1 -Device CDM ESD classification level --Pa171171 -QA C4A Class -OPA217...
Read more
Features Low noise, 80 nv P-P (0.1 Hz to 10 Hz) 3 nv/√Hz@1 kHz Low drifting, 0.2 volts/degrees Celsius degree High -speed, 17 volt/second conversion rate 63 MHz gain bandwidth Low input offset voltage, 10V excellent co -mode suppression ratio, 126 decibel (11 volt at the time Common voltage) High-opening gain, 1.8 million Replace 725, OP-07, SE5534 provide...
Read more
Features 2.7V to 5.5V power operation 50MHz serial interface 10MHz multiplier bandwidth [ 123] #8226: ± 15V Reference Input Low fault energy: 5nv-s extended temperature range: -40 ° C to++ 125 ° C 10 Director MSOP Pack 12 digits of monotonous Power -out -of -the -agencies of electricity detection Chrysanthemum chain mode Receivi...
Read more
The IC voltage of the working power supply is 5V 12V to the 12V bus up to 1.3A grid current capacity TTL compatible 5 digits of programming output符合VRM 8.5：1.050V至1.825V，二进制0.025V台阶电压模式PWM控制输出精度高：±1%[ 123] Overline and temperature Change Quick load transient response: from 0%to 100%duty cycle Power supply Good output voltage Overv...
Read more
1 general feature 1.5A internal switch The working input voltage from 4.4V to 36V 3.3V/(± 2%) reference voltage [ [ [ [ 123]输出电压可调1.235V至35V低压差运行：100%负载循环500KHz内部固定频率[ 123] voltage feedback Volidation current operation Internal current limit Zero current suppression Consumption Synchronous Feedback Protection Disglement Hot shutdown ...
Read more
Features Single power operation: 2.7 V to 12 V Wide input voltage range Output swing between the rail current 300 μA/300μA [ 123] Broadband: 3 MHz conversion rate: 0.5V/μs Low -dimensional voltage: 700 μV No phase reversal Application Industrial process control Battery power supply instrument Power control and protection Remote sensor Low -volta...
Read more
Features 4 ADCs are installed in a packaging Code serial digital output, each channel has ECC The temperature sensor on the film 95 DB channels are disturbing signal -to -noise ratio 65 dbfs, ain 85 mHz, 250 mSPS sfdr 77 dbc, Ain 85 MHz, 250 MSPS Excellent linearity dnl ± 0.3 lsb (typical) inl ± 0.7 lsb (typical) 780 MHz full power simu...
Read more
Features The complete power path management of the two people Battery, DC power supply, charger and backup power supply Compatible Battery Chemistry The 3 diodes mode ensure that the power supply can be available Under cold start conditions All N channel switching can reduce power Loss Capacitor and battery swing restrictions Seamless switching power supply ...
Read more
Application information is high enough to withstand the largest battery or charger output voltage. In most cases, this will allow the 20V MOSFET switch in the charger path, and the main power path is used to use the 30V switch. The surge current detection resistor, the RSENSE small value sensing resistor (current diversion) is paired by measuring and restricting flowing through...
Read more
Features 1.8V operation micro packaging bandwidth: 7MHz # 8226; cmrr: 90db (typical) conversion rate: 5V/μs Low offset: 500 μV (maximum) # 8226; Static current: 750 μA/channel (maximum) shutdown mode: lt; 1μA/channel signal adjustment ] Data Collection Process control Active filter Test equipment [123 123 ] Instructions ...
Read more
Features Low -current consumption: as low as 120 μA in the duty occupy ratio (typical value) Wide power supply range: 2.3 volts to 5.5 volts [ 123] programmable gain: 1 v/v to 128 v/v programmable data rate: as high as 2 KSPS 20 SPS 16 -bit noise -free resolution At the same time, inhibit 50Hz and 60Hz, 20 single -cycle digital filters dual matching progr...
Read more