General description lm117 The series of adjustable three -terminal positive voltage regulator can be output range of 1.2V to 37V. They only need only two external resistors to set the output voltage. In addition, lines and load adjustments are better than standard fixed regulators. In addition, the packaging of LM117 is easy to install for the installation. In addition to higher per...
Read moreGeneral description LMC7660 is a CMOS voltage converter that can be used from+1.5V to+10V to the corresponding negative voltage to -1.5V to -10VLMC7660 for the industry for the industry Standard 7660. Features of inverter: running full temperature and voltage range, no external diode, low static current, high power efficiency. LMC7660 uses its built -in oscillator to switc...
Read moreFeatures NTSC, PAL, SECAM, non-standard video synchronous separation video input level from 0.5VP-P to 2VP-P fixed fixation 70mv slice Low power supply current-1.5MA typical value. Single power supply+5V Compound vertical synchronization output ; Emergencies/gallery output Provide 8 LD PDIP and SOIC packaging Provide lead (in l...
Read moreFeatures li-agit or Li-POL cost management and single-chip synchronization DC-DC power converter to power the Bluetooth and optimize #8482; headphones and accessories [123 ] USB through AC adapters or the selection of autonomous power supply to the system charging and power supply Integrated USB charging control 500 mAh charging ratio Integrated power fiel...
Read moreFeatures Small 3-mm × 3-mm mlp (qfn) packaging -POL Space Co., Ltd. Application Integrated power field effect tube and current sensor, for charging applications up to 1-a reverse leakage protection prevent battery Discharge Integrated current voltage adjustment ± 0.5%pressure regulating accuracy ] Pre -charging adjustment with a safety timer LED...
Read moreThe power supply voltage is as high as 48V 5A maximum peak current ( l6201 maximum 2A) Total square root current L6201: 1A; L6202: 1.5AAA ; L6203/L6201PS: 4A RDS (open) 0.3Ω (typical value at 25 ° C) Cross -conductors TTL compatible drive ] The operating frequency is as high as 100 kHz Hot shutdown Internal logic power supply High efficienc...
Read moreFeatures NTSC, PAL, and SECAM synchronous separation single power supply,+5V operation accurate 50% Slice built -in programmable color emergencies Decoding non -standard vertical level synchronous output [[[ 123] synchronization pulse amplitude output low power consumption CMOS detection signal loss Scanning rate Few external compone...
Read moreFeatures Switch array serial programming parallel or serial mode ] Drive 150Ω load 60MHz 0.1dB gain flatness -300MHz 3DB bandwidth # 8226; skewers disturbance: 75db@100MHz After superimposed and switch, the 10NS internal channel stabilizes to 5% 356 stitch pbga packaging # 8226; Leadless (conforming to ROHS) Application Video Switc...
Read moreFeatures #10148; accurately measure the available power of nickel -cadmium, nickel -metal hydride and lithium ion batteries #10148; support SBSV1.0 data set and dual -line interface [123 ] #10148; Monitor the charge field effect tube in the lithium-ion bag protection circuit #10148; Designed for the integration of battery group -The low working current [ 123] -The entire cir...
Read moreGeneral description lm134 /LM234/LM334 is a three -ends adjustable current with 10000 : 1 working current range, excellent current adjustment and wide dynamic voltage voltage voltage The range of the range is 1V to 40V. The current is determined by an external resistor that does not require other components. The initial current accuracy is 3%. LM134/LM234/LM334 is a real float...
Read moreFeatures (v lm321 reduced performance and economy to CC 5 V, TA 25 ° C. Unless the power system. It has the frequency and regulations of the high unit gain.) The specified 0.4 volt/microsecond conversion rate, static current gain bandwidth product 1 MHz is only 430 -MA/amplifier (5 V). Input public low power current 430 Weian mode range includes grounding, so the devic...
Read more