• 2022-09-21 17:24:28

Description U2010B Designed as bipolar technology. It makes load current detection and soft startup function and reference voltage output. Feedback and overload protection with load current is the preferred application. Features full wave current sensor Compensation power change A programmable load current limit with overload and high load output Variable soft start V...

• 2022-09-21 17:24:28

Description UCC3915 A programmable thermal insertion power manager provides complete power management, hot insert capacity, and circuit breaker functions. The only external component required to operate the device, in addition to the power sources, is a fixed -time capacitor, CT. All control and room management functions are integrated and external programming. Including fault curre...

• 2022-09-21 17:24:28

Features * Simple interface with all microprocessors * Differential analog voltage input [123 ]* Run the voltage benchmark according to the ratio of 5 VDC voltage or simulation range according to the proportion or use of 5 VDC voltage or simulation range * 0V to 5V analog input voltage range, a single 5V supply * The clock generator on the film * TLL/MOS input/outpu...

• 2022-09-21 17:24:28

Features - High dynamic range - Output ip3: +28 dbm: R@250 mHz low noise coefficient: 5.9 decibel@250 MMB: [123 123 ] - AD8350 -15: 15 decibel -AD8350-20: 20 decibels ─3 decibel bandwidth: 1.0 Gigabit Hhe ] - Single power operation: 5 V to 10 V - Power supply current: 28 mia - Input/output impedance: 200 - Single -end or differential input driver -8-lea...

• 2022-09-21 17:24:28

General description lm2642 The switch frequency is synchronized by two current modes to 300 Qianhe. The two switch regulator controller is in the stage. This characteristic reduces the cubic cubic current current of the input ripples, which significantly reduces the required input capacitance. The output of the two switches can also be connected to the two -phase single output regulat...

• 2022-09-21 17:24:28

General description lm56 is a precise low -power thermostat. Two stable temperature trigger points (VT1 and VT2) are using 3 external resistors. LM56 has two digital output. When the output 1 becomes lower when the temperature exceeds T1, the temperature is higher than (T1 – THYST). Similarly, when the temperature exceeds T2, when the temperature becomes higher than the tim...

• 2022-09-21 17:24:28

Features * members of the PIN compatible TXDAC product series 125 MSPS update rate * 10 -bit resolution * Excellent and non -messy dynamic range performance * SFDR to nyquist@40 mHz output: 52 DBC * Differential current output: 2 mia to 20 mAh * Power consumption: 175 MW@5 volts to to 45 MW@3 volts * Power off mode: 25 mw@5 v * The reference volta...

• 2022-09-21 17:24:28

General description lmc662 CMOS dual operation amplifier is a single power operation. The working voltage from+5V to+ 15V is also available with rail -to -orbit output width and inputs that include grounding. The limitations of performance that troubles the CMOS amplifier in the past is not the problem of this design. Enter VOS, drift and broadband noise and actual load volt...

• 2022-09-21 17:24:28

Features * 4 -point frequency pre -scoring device High -frequency work: 4GHz to 18GHz * Integrated radio frequency decoupling capacitor Low power consumption * activation mode: 30 mAh * Power -off mode: 7mAh * Low phase noise: --150 dbc/hz * Single DC power supply: 3.3 V, compatible with ADF4XXX PLL * Temperature range: -40oc to+105oc * Small packag...

• 2022-09-21 17:24:28

Features * Maximum sampling rate: 65msps * 12 -bit resolution without lack of code ]* Power Consumption: 996MW * CMOS technology * Simultaneous sampling and maintaining * 10 MMC medium frequency 70.5 decibel signal -to -noise ratio * Internal and external reference * 3.3V digital/simulation power supply [123 [123 ] * Serialized LVDS output * Integr...

• 2022-09-21 17:24:28

Feature description lm3886 is a high -performance audio power supply 23 # 8226 ; 68W, VCC output power is 4Ω continuous output of 68W ± 28V continuously output 68W ± 28V The average power of 4Ω load and 38W to 8Ω 38W continuous output power, from 20Hz to 20kHz, 8Ω when VCC 0.1%Thd+N. The performance of 8 volts LM3886, using its own under VCC, the 50W c...