• 2022-09-23 10:09:12

feature High performance, 24-bit sigma-delta ADC; 115 dB dynamic range at 78 kHz output data rate; 112 dB dynamic range at 156 kHz output data rate; 156 kHz maximum fully filtered output word rate; pin selectable oversampling rate (128 × and 256 × low-power modes); flexible SPI; fully differential modulator input; on-chip differential amplifier for signal buffering; full-band low-pas...

• 2022-09-23 10:09:12

feature High breakdown voltage typical 120 V Low capacitance 0.017 pF typical Low resistance 4.7Ω typical Rugged Construction Minimum Lead Pull 4g Nitride Passivation illustrate The structure of the HPND-4005 Planar Beam Leaded PIN Diode provides an excellent lead for achieving excellent electrical performance at high frequency. The high beam intensity provides the user w...

• 2022-09-23 10:09:12

feature ±1.5 A, 50 V continuous output rating; low rDS (on) DMOS output driver; programmable slow, fast and mixed current decay modes; serial interface control chip function; low power synchronous rectification; internal UVLO and Thermal shutdown circuitry; cross-current protection; sleep and idle modes. Designed for pulse width modulation (PWM) current control in two DC motors...

• 2022-09-23 10:08:20

feature Common Mode Input Range: 00V (VS=?5V) Protection Input: 00V Common Mode ±500V Differential Unit Gain: Maximum Gain Error 0.02% Nonlinearity: Maximum 0.001% Common Mode Rejection Ratio: Minimum 86dB application Current monitor battery voltage monitor ground circuit breaker input protection Signal acquisition environment in noise factory automation illustrate T...

• 2022-09-23 10:08:20

Designed for automated design verification, test and measurement The NI Vehicle Radar Test System (VRTS) provides automated radar measurements and obstacle simulation for automotive radar systems from 76 to 81 GHz. Engineers can use VRTS to test automotive hardware and software subsystems, including radar sensors, ADAS subsystems, and embedded software. VRTS has flexible...

• 2022-09-23 10:08:20

The remote detection example presented here features high reliability, easy connectivity, and ultra-low power consumption. These circuits are primarily intended for industrial environments that require stable communication and minimal battery maintenance. This solution combines the research progress of low power consumption and high precision amplification in recent years, and has the same low ...

• 2022-09-23 10:08:20

The ISL59910 and ISL59913 are three-channel differential receivers and equalizers. They all have three high-speed differential receivers with five programmable poles. This then sums the outputs of these pole blocks into an output buffer. The equalization length is set to single needle. The ISL59910 and ISL59913 outputs can also be put into a high impedance state, allowing multiple...

• 2022-09-23 10:08:20

feature AD5280 : 1 channel; AD5282: 2 channels; 256 positions; +10 V to +15 V single supply; ±5.5 V dual supply operation; fixed terminal resistance: 20kΩ, 50kΩ, 200kΩ; Scale preset; programmable reset; operating temperature: -40oC to +85oC; I2C compatible interface. application Multimedia, Video and Audio; Communications; Mechanical Potentiometer Replacement; Instrumentati...

• 2022-09-23 10:08:20

The ISL8308xE is a BiCMOS, ESD protected, 5V power supply that meets the RS-485 and RS-422 single-transceiver balanced communication standards. Each driver output, and receiver input, is protected against ±15kV ESD strikes without latching, and unlike competing products, this Intersil series is specified for a 10% tolerance supply (4.5V to 5.5V). The bus current of thes...

• 2022-09-23 10:08:20

feature • Internal frequency compensated unity gain • Large DC voltage gain: 100dB • Very low supply current drain ( 500µA ) - essentially independent of supply voltage • Broadband (unity gain): 1 MHz (temperature compensated) • Input common mode voltage range including ground • Differential input voltage range equals power; supply voltage • Low input offset voltage: 2mV • W...

• 2022-09-23 10:08:20

feature ●pin compatible with ADC7802 and ADS7803 ●Single power supply: +5V or +3.3V ●Low power: 14mW plus power off ●Signal to noise ratio at temperature: 69dB minimum, fIN = 1kHz; 66dB minimum, fIN = 50kHz Fast conversion time: 8.5 microseconds; includes acquisition (117kHz sampling price); four-channel input multiplexer ● Automatic calibration: no offset or gain adjus...