• 2022-09-23 11:55:58

The EL7536 is a synchronous, integrated FET 1A buck regulator with internal compensation. It has an input voltage range of 2.5V to 5.5V and can accommodate 3.3V, 5V or Li-Ion battery power. The output is externally programmable from 0.8V to VIN via a resistive divider. EL7536 has PWM mode control function. The operating frequency is usually 1.4MHz. Other features includ...

• 2022-09-23 11:55:58

illustrate The WM8501 is a line driver with integrated 1.7VRMS. It is designed for audio applications requiring enhanced load drive capability for high voltage output. The WM8501 supports data input word lengths from 16 to 24 bits and sampling rates up to 192kHz. The WM8501 includes serial interface port, digital interpolation filter, multi-bit Sigma-Delta modulator in 14 and ster...

• 2022-09-23 11:55:58

The BUL216 is manufactured with high pressure Multiepitaxial Mesa technology for cost effective high performance. it uses a hollow launcher structure to increase switching speed. The BUL series is a switch mode power supply consumable designed for lighting applications and low cost. Internal schematic SGS-THOMSON preferred SALESTYPE NPN TRANSISTOR High ...

• 2022-09-23 11:55:58

CSD16323Q3 is a photocoupler, which is output by a phototransistor. Point-of-load synchronous buck converter optimized for control or synchronous FETs, describing continuous drain current, TC = 25°C 60 A.ID continuous drain current 21 A. Designed with NexFET 8482 ; power MOSFETIDM pulsed drain current, TA = 25°C(2) 112 A minimizes power conversion losses and opti...

• 2022-09-23 11:55:58

Features In-system programmable 3.3V proms Xilinx FPGA Configuration 20,000 program/erase cycle endurance Program/erase over full industrial voltage and temperature range (–40°C to +85°C) IEEE Std 1149.1 boundary scan (JTAG) support JTAG command initiates standard FPGA configuration Simple interface with FPGA Cascaded storage of long or multiple bit streams L...

• 2022-09-23 11:55:58

illustrate The ZXS C410 is a voltage mode boost converter in a SOT23-6 package. Very good load and line regulation means that the variation in output voltage is typically less than 1% over the full supply range of the Li-Ion battery. Using high-efficiency Zetex switching transistors allows output voltages to be in the tens of volts, depending on the transistor chosen. The ZXSC 42...

• 2022-09-23 11:53:15

illustrate The YB1231 is a series of ultra-low noise, low dropout (LDO) linear regulators with 2.0% output voltage accuracy. The YB1231 type regulator outputs 4.5 V at a 600 mA load current voltage range from 3.2V to 4.5 volts, 0.1 volts per level (custom voltages are considerable upon request). The YB1231 regulator is optimized to use low ESR and low cost ceramic capacitors, red...

• 2022-09-23 11:53:15

Device Description ZNBG series devices are designed to meet the bias requirements of GAAS, HEMT field effect tube receivers LNB, PMR, mobile phones, etc. commonly used in satellites. At least there are external components. Together with the two capacitors and resistors that provide the drain voltage and some external current-controlled ground source FETs, the regulated neg...

• 2022-09-23 11:53:15

General Instructions , with a redesigned processor core without wasting clocks and memory cycles. So it executes every 8051 instructions faster than the original 8051 at the same crystal speed. Typically, the instruction execution time of the W77L516A is 1.5 to 3 times that of the conventional 8051, depending on the type of instruction. Generally speaking, the overall performance is 2.5 ti...

• 2022-09-23 11:53:15

illustrate The YB1200 series includes 150ma ultra-low noise, low loss (LDO) linear regulators designed for battery powered RF and wireless applications. The YB1200 regulator achieves a low 250mV drop load current 3.3V output at 150mA, ultra-low output 15μvrms voltage noise and psrr, and 57dB at 1kHz. The YB1200 regulator is also optimized to use low esr and low cost ceramic cap...

• 2022-09-23 11:53:15

BEL Power Solutions - Point-of-Load Converters are recommended for regulated bus converters in Intermediate Bus Architecture (IBA). YS12S10 Product Specifications, Documentation and Sourcing Information" target="_blank">The YS12S10 non-isolated DC-DC converter provides up to 10 A of output current in an industry standard surface mount package. The YS12S10 convert...