• 2022-09-23 11:45:21

feature Industry Standard Pinout 4.5-V to 18-V Operating Range 5-A peak sink/source at VDD=12V; 4.3-A sink/2.8-A source at VOUT=6V; TTL or CMOS input threshold selection Three versions Dual independent drivers: - Dual Invert + Enable (FAN3223) - Dual Non-Invert + Enable (FAN3224) - Dual Input (FAN3225) - Internal resistor shuts down driver if no input...

• 2022-09-23 11:45:21

Features: Series Reference (2.5 V, 3 V, 4.096 V, 5 V); Low Quiescent Current: 70 µA Max; Current Output Capability: ±5 mA; Wide Supply Range: VIN = VOUT + 200 mV to 12 V ; Broadband Noise (10 Hz to 10 kHz): 50 μV rms; Specified Temperature Range: –40°C to + 125 °C; Compact Surface Mount SOT-23 Assembly. Applications: Portable battery powered equ...

• 2022-09-23 11:45:21

feature Highly flexible dual synchronous switching pwm controller includes the following modes: – DDR mode channel interference with non-inverting operation – 90° phase shift two-stage DDR mode input ripple – dual independent regulators 180 ° phase shift Complete DDR memory power solution – VTT tracks VDDQ/2 – VDDQ/2 buffered reference output Low-side mosfet or precis...

• 2022-09-23 11:45:21

The ZXSC400 is a voltage mode boost converter in a SOT2 3-6 package. Its low feedback voltage allows the current in the LED chain to be set and precisely monitored through a single resistor with minimal losses. Its excellent load and line regulation means that the variation in LED current is typically less than 1% over the full supply range of the Li-Ion battery. Using high-effi...

• 2022-09-23 11:45:21

Description YB1210R is a series of ultra-low noise, low loss (LDO) linear regulators with an output voltage accuracy of 2.0%. The YB1210R regulator achieves a low 320mV dropout at a 300MA load current at 3.3V output, with a voltage range from 1.2V to 3.6V with 0.1V per stage (custom voltages are considerable on request). The YB1210R regulator is optimized to work with low ES...

• 2022-09-23 11:45:21

Features: 750 mA continuous output current; 45 V output holding voltage; internal clamp diode; internal PWM current control; low output saturation voltage; internal thermal shutdown circuit; half-step or quarter-step for bipolar stepper motors Step operated dual full bridge pwm motor driver. describe The A2919 motor driver is designed to drive two windings of a bipolar stepper motor or bi...

• 2022-09-23 11:45:21

benefit Fully optimize system efficiency. Higher levels of efficiency compared to traditional discrete methods are achievable components. Save up to 50% of PCB space compared to discrete solutions. higher frequency of operation. Simplifies system design and board layout. Reduce time component selection and optimization. feature 12V Typical Input Voltage Output Current Up to 30A500k...

• 2022-09-23 11:41:16

Features: High cmv isolation: 2500v rms continuous; 63500 V peak continuous; small size: 1.00" 2.10" 0.350" 33; three-port isolation: input, output and power; low nonlinearity: 0.012% max6; wideband: 20kHz full power (–3dB); Low Gain Drift: 25 ppm/c68 max; High CMR: 120dB (G=100V/V); Isolation Power: 15V@5mA Uncommitted Input Amplifier 66. Applications: Multiplex data acq...

• 2022-09-23 11:41:16

feature Low power consumption with minimal impact on battery life Multiple power-down modes AC-coupled with DC balancing 100NA in standby mode, 5mA typical operating conditions Up to 24 bits Up to 20MHz Parallel Interface Operating Voltage Conversion from 1.65V to 3.6V Ultra-Small and Cost-Effective Package High ESD Protection: >7.5kV HBM Parallel I/O Power S...

• 2022-09-23 11:41:16

DESCRIPTION The YB1210 series consists of a series of 300mA ultra-low noise, low loss (LDO) linear regulators designed specifically for battery powered RF and wireless applications. The YB1210 regulator achieves a low voltage drop of 450mV at 250MA load current at 3.3V output, ultra-low output voltage noise of 15μVRMS and PSRR of 57dB at 1KHz. The YB1210 r...

• 2022-09-23 11:41:16

Block Diagram Description The VNI4140K is a monolithic device fabricated using STMicroelectronics ViPower technology to drive four separate resistive or inductive loads with one side grounded. Active current limit avoids system power loss during short-circuit loads. A built-in thermal shutdown protects the chip from overheating and short circuits. In an overload situation, the chan...