Features A single 3.3V power supply High -performance clock generator, including the crystal oscillator circuit of the integrated frequency synthesizer low output jitter, as low as 380 FS (RMS integrated between 10 kHz –20 MHz) low phase noise at high frequency; at 708 MHz, at 10 KHz at 10 KHz Small than -109 DBC/Hz, less than -146 DBC/Hz support fr...
Read more
Features 100%test settlement time 340ns typical value At the node is 1MV, 10V step maximum 540ns Test with fixed feedback capacitors The minimum rotation rate is 60V/μs gain bandwidth product 14MHz Power bandwidth (20VP-P) 1.2 MHz The unit gain is stable; 123] The input bias voltage maximum 600 μV Input bias current 25 ° C maximum 75Pa 70 ° C maximum ...
Read more
Features Two linear cone digital programmable potentiometers Each potential calculates 64 resistance connections end resistance 2.5 k , 10 k , 50 k or 100 k Potching control and memory access through the I2C interface Low wipers resistance, usually 80 #8222; Non -easy loss memory, each potential meter can set up to four wiper When power -on, automatically call the s...
Read more
Features Standardized symmetrical output features mid -speed operation: –Tphl, TPLH 30ns, 10V (typical) #8226; Test static current at 20 V under 20 V 18 V, the maximum input current is 1 μA The packaging temperature range, 18 V and 25 ° C are 100 na Meet the tentative requirements of jedec standard 13B, B series CMOS device...
Read more
Features Easy Integration Covering area 1.00 x 2.50 full dual -work 2400bps [ 123] Low power consumption v.24 DTE interface single+5V power operation # 8226; support protocol: v.22bis, v.23, v.22 Ul recognized component 123] FCC Part 68 Approval (user can be transferred) Application Automatic vending machine/game machine set -top box ...
Read more
External direct drive Dallington Electric Power Company coil current charging angle (resident) Control Program oil current peak limit [ 123] Programmable stop recovery time When 94%of the rated current does not reach Speed output permanent conduction protection External Darlington Overvoltage protection Internal power supply Qina Inverse protection of batteri...
Read more
0.5A output current 8 to 35 V power supply voltage range External programming current Limit Non -dissipated over current protection [ 123] Hot shutdown HYS Teresys IOlining Holding Diagnostic output with too low voltage, high temperature and excessive temperature ] External asynchronous reset input Preset delay of overload diagnosis Open ground prote...
Read more
Features 3.3V logic interface TTL logic level input Intelligent logic for power -powered/hot insertion state control [[ 123] single -chip integrated circuit reliability low match Ron 8226; Flexible switching time can be converted from a ringtone mode to a call mode. Clean, bouncing switch level three -level protection, including integrated flow limit, voltage c...
Read more
Features 5.5 × 3 mm small packaging designed for portable applications for single battery lithium ions or lithium polymers Integrated dynamic power supply path management (DPPM) function, allows the AC adapter to supply the system and charge the battery at the same time the power supply supplementary mode allows battery supplementary AC input current Independent po...
Read more
LP2950 and LP2951 are specially designed by micro-power pressure regulator to maintain properly adjusting low input-output voltage differences. The characteristics of these devices are that the low static bias current is 75 A, which can provide an output current exceeding 100 mAh. Internal current and heat provide restrictions and protection. LP2951 has three additional functions. T...
Read more
Features Integrated power field effect crystal tube and current sensor, which is used to exchange adaptors up to 1-A charging application saver with a safe timer Charging adjustment good state output of charging and power supply low -power automatic sleep mode integrated charging current monitor Fixed 7 -hour fast charging safety timer applicable to low -voltage d...
Read more