Features ● High linear approximation of limit ● Quick recovery of overspeed: 1NS ● Restricted voltage accuracy: ± 10mv ● —3db Bandwidth (g u003d+6): 260MHz ● Bad bandwidth multiplication: 1000MHz ● G ≥+4V/V stable ● Conversion rate: 1400V/μs [123 [123 ] ● ± 5V and+5V power operation ● Low -gain version: OPA698 Application ] ● Quickly li...
Read more
Features 0.5A output current 8V to 35V power supply voltage range Internal current limit Open open Ground protection Internal negative voltage clamping, rapid demagnetization Division input range and threshold lag Relax hturium lock Air load detection Two diagnostic output Output state LED drive No short circuit protection Anti -sudden transient (IEC...
Read more
Features Micro power 1.5μW (1 sample/second) 2.8V to 16V width power range High precision ] Maximum guarantee setting value error ± 0.5mv Guarantee 0.1%of the maximum value of the dead area Wide input voltage range V+to the ground TTL output with 5V power supply TTL supply Two independent ground reference control input Small size 8 -needle so Appli...
Read more
Features Low power current: maximum 600 μA OP07 type performance offset voltage: maximum 20 μV offset voltage drift: maximum 0.6 μV/° C Extremely low -pressure current 25 ° C: maximum 100 PA 55 ° C to+125 ° C: maximum 250 PA High -co -model suppression: minimum 114 db Extended industrial temperature range: 40 ° C to+85 ° C General description ...
Read more
Features ● Broadband+5V work: 225MHz (g u003d+2) ● Unit to stable: 280MHz (g u003d 1) ● High -output current : 150mA ● Output voltage switching: ± 4.0V ● High conversion rate: 2100V/μs ● Low power supply current: 6MA/CH ] ● Low -loss current: 200 μA/CH ● Enable/disable time: 25ns/100ns Application ● XDSL line drive ● Matching matchi...
Read more
Function description LM4670 is a completely integrated single power supply high no output filter inductance load high -efficiency switch audio amplifier. It is characterized by an external -configured gain innovation modulator to eliminate the very fast opening time of LC output: 1.35ms (typical value) filter with typical switch amplifiers. Eliminate the output filter to reduce the cou...
Read more
Working power supply voltage 8V to 28V, maximum 40V overvoltage The voltage of the working power supply voltage 6V implemented Static current in the standby state is less than 50 μA ISO 9141 Compatible interface Charging pump MOS that drives the power supply as reverse battery protection PWM operating frequency is as high as 30 kg A programmable cross -conduction ...
Read more
Features ● Low power: 50MW/Chan. ● Stable unit gain bandwidth: 360MHz ● Fast settlement time: 20ns to 0.01% ● Low harmonic: 5MHz at -77dbc ● Differential gain/phase error: 0.01%/0.025 ° ● High -output current: 85ma Amplifier ● CCD imaging amplifier ● Ultrasonic signal processing ● ADC/DAC gain amplifier ● Active filter ● High -speed in...
Read more
Features Low noise: 4.5 kilus 10 kHz at 3.8 nv/√Hz #8226 ; Low induction: 1 kHz is 0.00005% Low static current: each channel 2 mia Low input bias current: 10 PA [123 123 ] conversion rate: 10 v/μs width increase bandwidth: 18 mHz (g u003d+1) unified gain stability stable Rail transfers wide supply range: ± 2.25 volts to ± 18 volts, or +4.5 volt...
Read more
Features Full integrated solution MOSFET, reverse blocking diode, induction resistance, heat protection ideal choice of coke and graphite anode single battery [123 ] Lithium-ion bag Linear and quasi-pulse operation closed-loop heat control USB bus compatibility The programmable charging current is as high as 1A [ 123] Programmable pre -charging current The endin...
Read more
Pre -charging voltage If the VPRE pin is floating, the default value of VPRETH is set, which is equal to 2.8V (VPRETHDEFAULT). Otherwise, the device can program the value between the value between the VPRE pin and GND by connecting the resistor, Figure 12. In this case, RVPRE is given by Formula: Among them, RVPRE is the resistance between V...
Read more