Functional description LMX2502 and LMX2512 highly integrated, high and small size performance, low power frequency synthesizer –5.0 mm x 5.0 mm x 0.75 mm 28 -pin WQFN system, optimized Korean PC and Korean computers Packaging honeycomb CDMA (1xRTT, IS-95) mobile phone. In terms of the radio frequency synthesizer system that uses proprietary digital locks, LMX2502 a...
Read more
Features ● Low power current: 1 μA ● gain bandwidth: 70kHz ● Uniform gain stability ● Low input bias current: 10Pa (maximum) ● Wide power supply range: 1.8V to 5.5V ● Input range: 200mv beyond track ] ● Output drive current: 8mA ● Open loop gain: 90db ● Micro packaging: SC70, SOT33-5, SOT33-8 ] ● battery pack and power supply ● Portable...
Read more
Features 1LMH6570 is a high -performance simulation device 500 MHz, 500 MVPP, 3 dB bandwidth, AV u003d 2 is a multi -way reused device with professional -level video optimization 400 MHz, 2VPP 2VPP , 3 DB bandwidth, AV u003d 2 and other high -fidelity, high bandwidth simulation 8 NS channel switching time applications. The output amplifier selects a sel -based 10...
Read more
Features Broadband buffer: 700MHz, g u003d+1 Broadband line drive: 200MHz, G u003d+2 High-output current: 140mA Low power current: 5.5mA/CH Super Small packaging: SOT23-8 Low DG/Dφ: 0.05%/0.03 ° High conversion rate: 335V/microsecond Power voltage: ± 3V to ± 6V Application A/D drive Consumer video ] pulse delay ...
Read more
Features 0 ° C to 70 ° C. Knowing good molds separation (saw) mold installed on a wafer belt Control the baseline Low static current (IQ): 45μA (typical value) low cost #8226; Rail -to -track input and output Single power supply: 2.1 v to 5.5 v Input bias current: 0.5 PA (typical value) [123 123 ] High speed: Power bandwidth: 1MHz Appli...
Read more
OPA241 series is optimized for+5V power supply. OPA251 series is ± 15V power optimization. Features ● Micro power: IQ u003d 25 μA ● Single power operation ● Rail transition from orbit (within 50mv) ] ● The supply range is wide - Single power supply:+2.7V to+36V - Dual power supply: ± 1.35V to ± 18V ● Low offset voltage: Maximum ± 250 μV ● H...
Read more
Features PFC part -The transition mode PFC Protection - Overvoltage protection - Feedback disconnection - IOU lock –PFC clustering circle saturation detection –THD optimizer Half bridge section ] - Preheating and ignition phase Independent programming -3%oscillator accuracy -1.2μs dead area - programmable and programmable and can be programmed a...
Read more
The starting order of the old light or damaged light When an old lamp is connected to the ballast, the impact voltage is higher than the nominal value voltage and may be higher than the safety threshold. In this case, the lights may be longer than the ignition time or no time. In these two cases, during the ignition, due to the decrease in the frequency, the voltage at the output end of the...
Read more
Features ● Single power operation ● Rail transition (within 3mv) ● Micro power: IQ u003d 20μA/amplifier ● Micro packaging ● Low offset voltage: maximum 125 μV ● It is specified as vs u003d 2.3V to 5.5V ● Single, double and four versions Application ● Battery power supply instrument chart ● Portable device ● High impedance application ● Optic...
Read more
Features ● Rail -to -track input and output ● High output current: 660 mAh [ 123] ● Single power supply: +5 V to +12 v ● Broadband: 5 MHz ● High conversion rate: 3V/MS ● Low distortion: 0.01% ● The unit gain stable ● No phase reversal ● Short -circuit protection ● Drive capacitance load: 10 nf [ 123] ● Multimedia ● Telecom ...
Read more
Function description LM5070 power interface port and pulse width is completely compatible with 802.3AF power interface port modulation (PWM) controller provides complete 80V, 1 , 400 mA internal MOSFET integrated solution, applicable In the programmable wave current restricted access to Ethernet power supply (POE) system. This detection resistance blocking function LM50...
Read more