• 2022-09-24 23:30:48

The HIP1020 is suitable for any combination of MOSFETs with a linear ramp voltage gate of 3.3V, 5V and 12V. The internal charge pump doubles the 12V bias or triples the 5V bias to provide customers with high-side driver capability when more cost-effective N-channel MOSFETs are required. 5V/ms ramps the internal control rate and turns on is the correct value for the di/dt li...

• 2022-09-24 23:30:48

The Texas Instruments HPC3130 is a Peripheral Component Interconnect (PCI) hot-plug controller that is compliant with the PCI hot-plug specification revision 1.0. This device supports hot-plug/removal of up to four hot-plug slots on the PCI bus, provides a 64-bit data path in any of the four hot-plug slots, and supports two slots in a 66 MHz system. The main function of the H...

• 2022-09-24 23:30:48

Features 33% smaller than the SOT-232 small pass element is the only external part meaningless resistor auto-adaptation *Pass element short circuit protection* UV and POR Monitoring Circuits 2.5S auto-retry ±10V to ±72V input voltage range 0.6mA typical operating supply current Built-in AC interference path opening clamp application - 48V central office switching (line card) ...

• 2022-09-24 23:30:48

Features No External Parts Board 80V, 2A MOSFET No Rsense Requires ±8.0V to ±80V Input Voltage Range Secondary Current Limit 1.2A initial surge current limit 2.0A Two inrush current limit / circuit breaker trigger servo TOC limit 1.2A, then turn off fast response current limit when input voltage overcurrent or step (eg diode OR'ing) Programmable under-voltag...

• 2022-09-24 23:30:48

Supertex HV300 and HV310, hot-swappable controllers, control the negative supply, when plugged into the power supply to connect to a live backplane card or module. They can be used with conventional "negative 48V" or higher voltages to power system buses up to negative 90V. Prevents spin glitches during initial power-up operation, (typically found and after the load capacitance is fully c...

• 2022-09-24 23:29:15

This family of fully featured hot-swap power controllers targets applications in the +2.5 V to +12 V range. "ISL6115, ISL6116 are +5 V, +12 V controls the ISL6117 is +3.3 V and 2.5 V controls the ISL6120 application. Each has a hard-wired undervoltage (UV) monitor and reports a threshold level of approximately 80% of the above voltage. The ISL6115 has an integrated charge...

• 2022-09-24 23:29:15

Applications Battery powered instruments Power supply voltages for cellular phones Cameras and video recorders Handheld computers Preliminary CMOS low power consumption Small input-output voltage difference: 0.18V at 60mA, 0.58V at 160mA Maximum output current: 165mA (VOUT=3.0V) High accuracy: ± 2% (± 1%) Output voltage range: 2.0V~6.0V Standby current 0.1μA (VOUT...

• 2022-09-24 23:29:15

The ZMR series three terminal fixed positive voltage regulators have internal current limiting and shutdown under thermal overload conditions, making the device difficult to destroy. The circuit design provides an exceptionally low quiescent current, only 30mA for 2.5V devices, ideal for low power applications. The initial device specification in the series is with drive capability up to 2...

• 2022-09-24 23:29:15

The ADM1014 is a dual PCI voltage bus controller that allows hot-plugging of adapter cards to and from the backplane, either actively or passively. The device requires only 4 external power supplies for a complete MOSFET and a few discrete components for a power control solution for two PCI slots. The ADM1014 operates from +12 V and +3.3 V auxiliary supplies and controls fiv...

• 2022-09-24 23:29:15

The TLE 4117 is a 3 positive adjustable or fixed voltage regulator. It is capable of delivering 800 mA of output current. Fixed voltage devices for 1.8 V, 2.5 V, 3.3 V and 5 V output voltages. The regulators require 2 to 2 external resistors to define output voltages of 1.25 V and 40 V in TLE 4117 surface mount D-Pak packages. The TLE 4117 regulator family provides complete ...

• 2022-09-24 23:29:15

Features Output Voltage Tolerance: ±2% Very Low Current Consumption Low Voltage Drop Thermal Protection Reverse Polarity Proof Wide Temperature Range Suitable for Use in Automotive Electronics Suppression Function description The TLE4266G is a 5-V low dropout regulator for a P-SOT223-4-2 SMD package. "The IC regulates the input voltage Vi in the range of ...