illustrate The CS8312 is a bipolar microprocessor interface IC designed to drive IGBTs (or logic level MOSFETs) to power large inductive loads in harsh operating environments. The dynamic current limit function allows the microprocessor to adjust the current limit threshold for the real-time demand system. In the CLI, enter the current limit and set the current limit of the IG...
Read more
describe: The FCT162244T 16-bit buffer/line driver is suitable for bus interface or signal buffering where high speed and low power consumption are required. These through-pin devices have an organizational process that simplifies and shrink wraps the board layout. All inputs are designed with hysteresis for improved noise tolerance. Tri-state control allows independent 4-bit, 8-bit or com...
Read more
DESCRIPTION The Edge211 is a dual ternary driver in the full process of manufacturing voltage CMOS. It is designed for automatic test equipment and instrumentation at a premium in cost, functional density and power. Each tristatable driver is capable of generating 3 levels - One is a logic high, one is a logic low, for either a termination voltage or a special programming volta...
Read more
Features • PWM Controller + Sense CoolMOS in a compact package • 600 Volt Avalanche Rugged CoolMOS • Typical RDSON=0.5...3.5 at temperature Tj=25 °Ωç • Only 4 Active Pins • Standard DIP-8 Package Output Power ≤ 40 Watts • Few External Components • Low Startup Current • Current Mode Control • Input Under Voltage Lockout • Max. Duty Cy...
Read more
Overview The integrated circuit TDA8380A is used as a low-cost control circuit for switching power supplies for televisions, monitors and small industrial equipment. Operates using the TDA8380A in fixed tax factor regulation frequency mode. Features · A low current initialization circuit (150 mA max) that can be turned off · A bandgap reference voltage generator · Slow start of ...
Read more
General description The MAX1614 driver's high-side N-channel power MOSFET provides battery power switching in portable functional devices. N-channel power MOSFETs typically have one-third the on-resistance of P-channel MOSFETs in comparable size and cost. The high-side drive output voltage generated by the internal voltage regulator and micro-charge pump requires no ...
Read more
The ISL6700 is an 80V/1.25A peak, IF, low cost, half bridge driver IC in an 8-lead SOIC package and a 12-lead QFN plastic package. The low-side and high-side gate drivers can be independently controlled and matched to 25ns. This gives the user maximum flexibility in choosing and driver protocol at the time of death. Undervoltage protection is low on both the low-side and high-s...
Read more
General Description This is a hex-buffered monolithic complementary metal-oxide-semiconductor (CMOS) integrated circuit built with N- and P-channel enhancement-mode transistors. The logic level conversion of the device uses only one power supply voltage (VDD). The high level (VIH) of the input signal can exceed the VDD supply voltage when the logic conversion of the device is p...
Read more
Description The L6353 device is intelligently driven, with all drive and protection knowledge "shipped". Available in both DIP and SO packages, a logic level or pulse transformer can be triggered from a signal optocoupleror. It filters parasitic input signals and drives any MOSor IGBTs. Features Peak High Output Current Capability (+8A) Wide supply voltage range (12.5 to 1...
Read more
Over-voltage charge pump automatic shutdown for VVS>25V reverse battery protection (refer to the application circuit diagram) Programmable overload protection function channels 1 and 2 Open ground protection function channels 1 and 2 Constant gate charge/discharge current DESCRIPTION The L9380 device is a "high-side switch" configuration of three external controller N-channel...
Read more
The general description of the LM2722, part of the LM2726 family, is intended to be used with multiphase controllers. This part differs from the LM2726 by changing the pin function of SYNC_EN from full chip startup to low-side MOSFET enable. With this, the SYNC_EN pin now provides control between synchronous and asynchronous operation. With this control can be an advant...
Read more