News

  • 2022-09-23 12:41:07
Inside the CAT25256 is an EEPROM serial 256-Kb

Inside the CAT25256 is an EEPROM serial 256-Kb SPI device organized as 32Kx8 bits. This has a 64-byte page write buffer and supports the Serial Peripheral Interface (SPI) protocol. The device is enabled through the Chip Select (CS) input. In addition, a bus is required The signals are the clock input (SCK), data input (SI) and data output (SO) lines. The HOL...

Read more
  • 2022-09-23 12:41:07
DCR01 series are miniature 1W isolated regulated DC/D...

The DCR01 series is a series of high efficiency, input-isolated, output regulated DC/DC converters. In addition to 1W nominal galvanically isolated output power capability, this range of DC/DCS provides very low output noise, thermal protection, and high accuracy. The DCR01 series implements standard die IC packages, offering standard JEDEC profile suit- capable for high ...

Read more
  • 2022-09-23 12:41:07
ADM3307E/ADM3310E/ADM3311E/ADM3312E/ADM33...

The ADM3307E /ADM3310E/ADM3311E/ADM3312E/ADM3315E family of driver/receiver products are designed to be fully EIA-232 compliant and operate from a single 2.7 V to 3.6 V supply. These devices feature an onboard charging pump DC-DC converter, eliminating the need for dual power supplies. The DC-DC converter consists of a voltage tripler and a voltage inverter that...

Read more
  • 2022-09-23 12:41:07
VN02N high-voltage side intelligent power solid state rel...

Output Current (Continuous) 6a@ tc =25°C Five Watts 5V Logic Level Compatible Input Thermal Shutdown Description Under-Voltage Shutdown Open-Drain Diagnostic Output Use to drive resistive or inductive loads side ground. The built-in thermal shutdown protects the chip from short circuit due to excessive temperature. Input controls are compatible with 5 volt logic levels. T...

Read more
  • 2022-09-23 12:41:07
EL5164, EL5165, EL5364 are 600MHz current feedback a...

The EL5164 , EL5165 , EL5364 and amplifiers with current feedback feature a high bandwidth of 600MHz. This makes these amplifiers ideal for today's high-speed video and surveillance applications. With only 5mA supply current and the ability to run from a single supply voltage of 5V to 12V , the amplifier is also ideal for handheld, portable or battery powered devices. The EL51...

Read more
  • 2022-09-23 12:41:07
VV6501C001 36-pin CLCC color sensor

FeaturesTechnical Specifications 640 x 480 VGA resolution Image size 640 x 480 (VGA) 1/4" format Lens compatible pixel size 5.6 microns x 5.6 microns Onboard 10-bit ADC array size 3.6 mm x 2.7 mm onboard voltage regulator Analog gain x1 to x16 Auto Dark Calibration Car Audio Amplifier Sensitivity (typ) 2.05 V/lux sec I2c interface Maximum frame rate 30 fps (with 24MHz c...

Read more
  • 2022-09-23 12:41:07
X4003/X4005CPU Supervision

Features selectable watchdog timer - Select 200ms , 600ms , 1.4s, off low VCC detection and reset assert - Five standard reset threshold voltages rated 4.62V, 4.38V, 2.92V, 2.68V, 1.75V - Use a special programming sequence to adjust the low VCC reset threshold voltage -Reset signal valid until VCC=1V Low power CMOS -12µA typical standby current with watchdog on -800NA ...

Read more
  • 2022-09-23 12:41:07
BQ24703PW is a highly integrated battery

The BQ24703PW /bq24702 is a highly integrated battery integrated selector supporting battery charge controller and selector tuning and smart battery learning loop and sub-laptop applications tailored for notebook PCs. Zero Voltage Operation of the bq24702/bq24703 Using Dynamic Power Supplies A selector feedback circuit ensures management (DPM) to minimize battery charging time B...

Read more
  • 2022-09-23 12:41:07
FPF2108, FPF2109, FPF2110 are 200mA to 400mA curr...

The FPF2108 , FPF2109 , and FPF2110 are a series of load switches which provide systems and loads which may adequately protect against high current conditions. The device contains a 0.125 Ω current-limiting P-channel MOSFET that operates over an input voltage range of 1.8-5.5V . Internally, back current blocking prevents current flow when the MOSFET turns off and the out...

Read more
  • 2022-09-23 12:41:07
The ULN2803A is typically used to drive high voltage an...

Features The 500 mA rated collector current ULN2803A device is a 50 V, 500 mA Darlington (single output) transistor array. The device consists of eight NPNs. Darlington Pair with High Voltage Output High Voltage Output: 50 V Universal Cathode Clamp Diode Output Clamp Diode for Switching Inductive Loads. The current rating of each collector is 500 mA for inputs co...

Read more
  • 2022-09-23 12:41:07
DS2165Q is a digital signal processing (DSP) chip

The DS2165Q ADPCM processor chip is a dedicated digital signal processing (DSP) chip that has been optimized to perform Adaptive Differential Pulse Code Modulation (ADPCM) voice compression at 3 different rates. The chip can be programmed to compress (extend) 64kbps voice data down to (from) either 32kbps, 24kbps, or 16kbps. 32kbps compression follows the algorithmic recomme...

Read more