The EL5144 series amplifiers are voltage feedback, high speed rail-to-rail amplifiers designed to operate on a single +5V supply. They offer unity gain stability with unloaded -3dB bandwidth to 100MHz. The input common-mode voltage range extends from the negative supply line to within 1.5V of the positive rail. Driving 75Ω double terminated coaxial cable, the EL5144 series amplifiers...
Read more
The AD8314 is a complete low-cost subsystem to measure and control RF signals in the frequency range 100MHz to 2.7GHz with a typical dynamic range of 45dB and is designed for use in a variety of cell phones and other cell phone wireless devices. It offers a wider dynamic range and greater accuracy than using discrete diode detectors. In particular, it has very good temperature stabilit...
Read more
Description Application ZXCT1010 is a high side current detection monitor. Battery chargers use this device without interrupting the smart battery pack ground plane when inducing load current. DC Motor Control It is an enhanced version of the ZXCT1009 product. Over-current monitor reduces typical output deviation and improves accuracy for power management at low inductance voltage...
Read more
The BQ29330 is a 2-series, 3-series and 4-series Li-Ion battery pack fully protected analog front end (AFE) IC with built-in 2.5 V, 16 mA and 3.3 V, 25 mA low dropout voltage regulators (LDO). The bq29330 also integrates an IC-compatible interface to extract battery parameters such as battery voltage, individual battery voltage and control output status. Other parameters such ...
Read more
The HIP6012 provides complete control and protection of a DC-DC converter optimized for high performance microprocessor applications. It is designed to drive two N-channel MOSFETs in a synchronous rectified, buck version topology. The HIP6012 integrates all control, output adjustment, monitoring and protection functions into a single package. The converter's output voltage...
Read more
General Instructions The W83627HF and W83627F are products of Winbond's most popular I/O series. They offer a brand new interface, the LPC (Low Pin Count) interface, which will be available in the next generation of Intel chipsets. This interface, as the name suggests, is intended to provide an economical I/O interface implementation with a lower pin count and still maint...
Read more
The CDCE949 and CDCEL949 are low-cost, high-performance, programmable clock synthesizers, multipliers and dividers based on modular PLLs. They generate up to 9 output clock frequencies from a single input. Each output is in-system programmable for up to four independently configurable PLLs for any clock frequency up to 230 MHz. CDCEx949 has independent output power pins, V...
Read more
Data from the DS1821 can function as a standalone thermostat with a user programmable trigger point or as an 8-bit temperature sensor with a 1-wire digital interface. The trigger point for the thermostat is stored in non-volatile memory, so the DS1821 unit can be programmed for true stand-alone operation by plugging it into the system in advance. The DS1821 has an operating temperature ra...
Read more
Pin description The SPI chip select (/cs) pin enables and disables device operation. When /cs is high, the device is deselected and the serial data output (DO or IO0, IO1, IO2, IO3) pins are in high impedance. when? Deselected unless an internal erase, program or write status register cycle is in progress. When /cs goes low, the device will be selected, power consumption will inc...
Read more
EP5358xUI (X=L or H) is a 500mA PowerSOC. The EP5358xUI integrates MOSFET switching, control, compensation, and magnetics in an advanced 2.5mm x 2.25mm miniature QFN package. Magnetic integration technology enables tiny solution size, low output ripple, low component count, and high reliability while maintaining high efficiency. A complete solution can be implemented in...
Read more
The ADS805 is a 20MHz, high dynamic range, 12-bit pipeline analog-to-digital converter ADC. The converter includes a high bandwidth track and hold, providing excellent spurious performance that meets and exceeds the Nyquist rate. This high bandwidth, linear sample-and-hold function minimizes harmonics and has low jitter for excellent signal-to-noise ratio (SNR) performance. The AD...
Read more